MAINTENANCE
Solution Hose Connector:
Occasionally spray both the male and female parts of the connector with a general penetrating lubricant to prevent corrosion. Pull down moveable sleeve and spray underneath for best results.
Foam Dome
Occasionally spray both the male and female parts of the connector with a general penetrating lubricant to prevent corrosion. Pull down moveable sleeve and spray underneath for best results.
Clean vacuum filter by hand, or remove and rinse. To remove filter screen loosen hose clamp, remove vacuum hose from outside of dome, pass a screwdriver handle first in through the backside and gently tap on inside of filter till removed. During cleaning and while replacing be careful not to squeeze filter out of round.
Clean solution hose filter by hand, or if build up is present unscrew filter and soak overnight in a liquid calcium and lime eliminator. Rinse well and replace.
Spray Tip:
Periodically check the spray tip for residue or hard water build- up. If blockage is noticed soak the tip in a liquid calcium and lime remover overnight. It may be necessary to pass a very fine wire through the tip to dislodge the foreign material.
Brush Cleaning
Clean the beater brush after each rental using a wire bristle paint scraping brush. The wire tines of the paint scraping brush will grab the carpet fibers etc tangled onto the beater brush making the task must easier and faster. Wipe clean the bottom of the machine paying close attention to the area around the spray tip and brush.
Upholstery Tool Maintenance:
Flush unit with clean water after each use. Occasionally lubricate the trigger valve with a general penetrating fluid. Remove spray tip and soak in a liquid calcium and lime remover as needed.
Vacuum Shoe Maintenance:
Check to make sure the vacuum passageway has not become clogged with carpet fibers and lint. Pass a hacksaw blade up into the vacuum slot to clear. The teeth on the blade will grab onto the debris making removal fast and easy.
